Thank you for clicking over to have a look at my blog
Welsh Sympathy Card
A couple of days ago I posted the first in a series of posts about 3D printing. You can see it – here.
Today’s post is a bit of very clean “mixed media” LOL – made of cardstock and PLA+ filament.
I was very impressed with the detail achieved an such a thin item.
I then used a Tattered Lace corner die to cut into the corners of a sheet of white, linen textured, cardstock that had been cut to slightly less than A5 in size. I also cut some layers using other Tattered Lace dies – Tattered Lace Strung Lace Diamond Die and an oval die. All out of the linen textured cardstock. I even made the base card from the same cardstock.
I used some foam tape to attach some of the layers and wet clue to attach others.
I finished off by adding a peel off greeting “Gair o Gysur”.
This is what my card looked like after it was finished.
My nephew and I have more posts planned on his ventures into 3D printing, including the construction of the 3D printer used for the cross element on this card, so please keep an eye out for those.
You can see my page on Facebook by clicking – here.
You can see the cards I’ve made using design sheets from CUP in my “Crafter Showcase Area” on Craftsuprint.com – here
(Just scroll down past the top boxes to see the cards.)
(Thank you for reading this blog post. I hope you like what you’ve seen and read – You should find a box below where you can leave a comment if you feel like it – but due to the fact that, like many I’m sure, I’ve had some problems with Spam/advertising posts that are absolutely nothing to do with the content of my blog, I now moderate all comments before they go live. Genuine comments will go live when I’ve checked through the list – usually a couple of times a day.) (Thank you to every body who’s left comments on my previous blog posts. I really do appreciate them all.)
If you can’t see the comment box then there should be a link that says “Responses” and clicking on that will bring up the box